Manual placer CMS-100 is a low cost unit in our SMT prototype printed circuit board assembly program. These Pick and place machines come with the CMS-1000 Which is a professional manipulator arm, used for Pick & Place of SMD components and also for dispensing of solder cream and/or glue. The built-in spot light provides an optimal light source for your work. The manipulator arm has a unique switch feature for Pick & Place of components, operator can pick a component by placing the Pick & Place pipette in a descending motion over the component desired move the arm to the place on the circuit board where component goes then by turning the small knob on the arm the vacuum will be released and the component is placed. The same system is used for dispensing. By clicking the needle, glue or solder cream, it is dispensed either continuously or in small dosages. Arm can be operated left or right handed. Also it comes with a component holder with 42 separate anti static bins for SMT components. As options the placer can be used together with a vacuum pump CMS-50 or with the vacuum-dispense unit CMS-200. The CMS-100 cannot be used with feeder holder CFT-360.

Vacuum pump for use with CMS-1000 Compact (Manipulator arm)

Vacuum pump CMS 50
Input: 110VAC or 220/240VAC. 4Watt Vacuum pressure: 0.33Bar

Vacuum-Dispenser CMS 200
The CMS-200 is a microprocessor controlled Vacuum-dispenser unit, which incorporates a digital timer with adjustable dispense time. Low viscosity fluids can be easily dispensed with this unit, the barrel vacuum avoids dripping.
The CMS has also a vacuum output to connect the Pick & Place manipulator arm CMS-1000 Compact. Regulation of the vacuum depending the size of components to be used, can be adjusted by a vacuum valve.

Storage unit with 10 drawers. Each drawer has an insert tray with 35 antistatic bins.