Designed to work with lead-free paste (Sn96.5 / Ag3.0 / Cu.5). Before placing the PCB in the oven cut a piece of the Temperature Marker with a blade or a sharp knife and place it on the surface of the board next to a large component (PLCC or QFP). Make sure you can see the Temperature Marker material through the oven door. The Temperature Marker material is opaque initially but when 475 °F (246 °C) is reached the material liquifies and becomes shiny, non-reversibly.
Clock fast Lead Time: In stock and ready for shipment Money orange $13.00
HANDI-VAC KIT, Static dissipative, with static dissipative Buna-N vacuum cups. (1) 1/8” and (1) 1/4” vacuum cups on bent probes and (1) 1/8” and (1) 3/8” vacuum cups on straight probes. The vacuum-bulb type tools are the lowest cost pick-and-place tools available. These tools operate very similar to a tweezer. Simply squeeze the vacuum bulb, place the soft suction cup to the part to be handled, then relax your squeeze and the part is firmly gripped. A second squeeze releases the part.
Clock fast Lead Time: In stock and ready for shipment Money orange $18.00
Stencil Wipes are saturated wipes that can be used for stencil cleaning or misprint cleaning of PCBs. IPA/DI stencil wipes are packaged in containers of 100 wipes. STENCIL WIPES CAN ONLY BE SHIPPED USING GROUND METHOD.
Money orange $30.00
The CPF Clamp works only with the CPF stencil. It works by holding the stencil in place while the solder paste is being applied.
Money orange $39.00
×